Lon - Siemens Climatix Series Basis Document

Devices
Prerequisites
Commission controller
Note
Parameter
Parameter
State
Comm failure
Location
Application
Neuron ID
Send heart beat
Receive heart beat
124 / 244
Basis Document Siemens Climatix Control System
Siemens
Page 124
BDCX.100820.01GB
Building Technologies
9.3

LON

A LON interface is always available on the basis controller POL636.xxx.
The external LON module POL906.xx also required for controllers POL 635.xxx
and POL 638.xxx.
9.3.1 Commission internal LON interface
Participating devices
− Climatix POL 636 controller.
Prerequisites for commissioning a LON section:
– The SAPRO application is fully commissioned.
– Level 4 (password 2000).
– Mapping file (OBH.bin) is loaded.
Step Action
1 In the menu System parameter > Communication, select LON Con-
figuration.
2 Configure additional settings as required.
After successful LON commissioning via the LON tool, you can access the control-
ler via the LON bus using Saphir Scope.
Main Index > System overview > Communication > LON
Range
− OK.
− Alarm
− Passive
− Active
Standard application AHU
Communication
Function
LON bus state.
Communications error between LON and proc-
essor. (e.g. no LON application loaded on the
Neuron Chip)
Displays information that can be set via the LON
chip during bus commissioning.
Name of loaded LON application (list of LON
variable) on the Neuron chip.
Displays ID number for the Neuron chips.
Displays current interval for sending values.
Displays current interval for receiving values.
CE1P3977en_02
01.02.2010