Alarm Handling (Alarm Outputs) - Siemens Climatix Series Basis Document

Main Index > Unit > Operation Hours > Fan Settings
Parameter Function
OpHours alarm Operation hours alarm
Enble alarmOpHours Enables this Function, if the Operation
Hours from Supply Fan are > than OpHours
Limit => alarm
OpHours Limit Operation hours Limit
Main Index > Alarm handling
Parameter Function
Alarm acknowledge Reset button for Alarms
Danger (A) Aktual Status of Danger Alarms
Critical (A) Aktual Status of Critical Alarms
Low (B) Aktual Status of Low Alarms
Warning (C) Aktual Status of Warnings
Alarm outp 1 select Selection of signalised Alarms if only one
Alarm output is activated
High (A) = only High class Alarms
H+L (A+B) = High and Low class Alarms
Alarm output 1 Actual Status from output 1
Alarm output 2 Actual Status from output 2
Modbus communicat Error Status from MODBUS communication
(1 = Alarm)
Comm module 0 Jumpline to Communication modele
overview
Comm failure Comminication failure in Module 0
State Reason for Failure in Module 0
Comm module 1 Jumpline to Communication module
overview
Comm failure Comminication failure in Module 1
State Reason for Failure in Module 1
Comm module 2 Jumpline to Communication module
overview
Comm failure Comminication failure in Module 2
State Reason for Failure in Module 2
Siemens
Building Technologies
17.20.2 Fan settings

17.21 Alarm handling (Alarm outputs)

Basis Document Siemens Climatix Control System
Standard application AHU
BDCX.100820.01GB
HMI
Value range Unit
Active, Passive
No, Yes
0...999999 h
Value range Unit
Off, On
Normal, Alarm
Normal, Alarm
Normal, Alarm
Normal, Alarm
High (A)
H+L (A+B)
Normal, Alarm
Normal, Alarm
0...1
Passive, Active
Ok
Hardware
Init
Memory
DoubleID
COV Reg
other
Passive, Active
Ok
Hardware
Init
Memory
DoubleID
COV Reg
other
Passive, Active
Ok
Hardware
Init
Memory
DoubleID
COV Reg
other
Standard R S Link
X
No 6
17520 6
Standard R S Link
4
X
X
X
X
4
X
X
X
4
X
X
Section:
5.14
4
X
X
4
X
X
211 / 244
CE1P3977en_02
Page 211
01.02.2010