Final Checks; Removing From Pallet; Test Driving; Miscellaneous - Stiga Park 2WD Workshop Manual

1.3.3 Final checks

Removing from pallet

All the above measures shall have been done with the machine standing on the pallet.
Now, loosen the remaining straps and roll off the machine from the pallet.
Fit and adjust accessories.

Test driving

Warning!
Do not drive without a work equipment (mover deck) attached. Risk for
turning over.
Drive the machine for a few minutes. Test all the functions. Pay special attention to the
safety functions. If the machine is to be delivered with mower deck or other accessories,
fit these before test driving the machine.
HST oil
Check the oil level in the HST's expansion tank after test driving, and top up if
necessary.
Engine oil
Check the oil level in the engine and top up if necessary.
Steering chain / Steering wire
Check that the steering chain / steering wire is sufficiently taut. Adjust if necessary.

Miscellaneous

Give the machine a general inspection.
• Is the machine clean?
• Is there any oil leakage?
• Abnormal noise or rattle?
Receipt
By filling in the guarantee certificate you guarantee that the delivery service has been
correctly conducted.
Remember to make sure that the customer receives all the documentation when the
machine is collected / delivered.
WORKSHOP MANUAL
PARK
Chapter
1 - General instructions
EDITION Page
6
2018