Tyres, Air Pressure; Engine Oil And Oil Filter; Belt Transmissions, Check; Battery, Check - Stiga Park 2WD Workshop Manual

2 Tyres, air pressure

Check the air pressure. Adjust if necessary.
The recommended air presure is
designated at the floor mat.

3 Engine oil and oil filter

See the "Instructions for use", delivered
with the machine or "Instructions for use" at
page 31. See also the engine manufacturer
manual.
4 Oil, HST
See section 4 or the "Instructions for use",
delivered with the machine.

5 Belt transmissions, check

Check the condition of all the belts and belt
tensioners.
6 Steering, adjustment
See section 3.

7 Battery, check

Valid for dry charged batteries only.
Check the acid level. Top up with distilled
water if necessary. See page 6-7.
8 Engine air filter
See the "Instructions for use", delivered
with the machine. See also the engine
manufacturer manual.
9 Catalytic converter air filter
See the "Instructions for use", delivered
with the machine. See also the engine
manufacturer manual.
10 Cooling fins
Remove protective covers from the engine
and cleans between cooling fins. Use a
brush and compressed air. See also the
engine manufacturer manual.
WORKSHOP MANUAL
PARK
Chapter
1 - General instructions
11 Spark plug
Remove the spark plug (not valid for Pro
Diesel) and clean it or replace if necessary.
See also the engine manufacturer manual.
12 Lubrication
Lubricate the articulation point (4 nipples)
and all moving parts such as wires and
levers. See also the instruction manual,
delivered with the machine.
13 Transmission
Listen for abnormal noise.
Manual models: Check that the drive
function works properly at all gears. Adjust
if required.
14 Speed check
Check that the speed corresponds to the
specified value. See pages 18-22.
15 Bearing boxes
Listen for abnormal noise from the
bearings. Check that there are no wear,
play or seizure.
16 Exhaust system
Check that there are no cracks, leakage or
other damages. Check the attachment
devices. See also the engine
manufacturer manual.
17 Electrical system
Check that there are no damaged cables,
contacts or other devices. Check that all
cables are properly secured to the chassis
and with cable holders. Check that there is
no friction between cables and chassis,
which can result in cable damage and
short circuit.
EDITION Page
12
2018