Stiga Park 2WD Workshop Manual page 111

Valid for (
Art. Number)
13-6272-XX 13-6312-XX
Fault
The engine can be started
with the mower deck activated.
The mower deck does not
disengage when the operator
leaves the seat and the mover
deck is activated.
The engine does not stop.
The speed cruiser does
not disengage when the brake
pedal is pressed.
The engine can be started
without the brake pedal
pressed.
The engine can be started
without the operator in the seat,
brake pedal pressed and deck
not activated.
The starter does not rotate and
there is no "click" heard at the
start attempt.
The starter does not rotate and
there is a "click" heard at the
start attempt.
The starter rotate, but the
engine does not start.
The battery runs repeatedly
empty.
WORKSHOP MANUAL
PARK
-
Cause/Alternative
Fault in the safety circuits.
Faulty start motor or start relay
A connected voltmeter to the
battery shows a higher voltage at
high speed than if the engine not is
running.
No voltage different.
Chapter
7 - Electrical System
1005-0088
-
Action
Adjust or replace the mover deck switch.
Replace the seat switch.
1. Check the white cable and its
2. Replace the ignition switch.
1. Clean the brake plate. See section 3.
2. Adjust/replace the pedal switch.
Replace/adjust the pedal switch.
Adjust/replace the seat switch.
1. Adjust/replace the pedal switch.
2. Adjust/replace the seat switch.
3. Adjust/replace the mover deck switch.
4. Replace the ignition switch
1. Check cable connections.
2. Replace the start relay.
3. Replace the start motor
1. Check the fuel supply.
2. Check the engine according to
3. Check that the white short circuit cable
4. Replace the ignition switch.
5. Replace the shut off valve.
Replace the battery.
1. Check engine socket connections.
2. Replace the ignition switch.
3. Replace the voltage regulator.
4. Replace the alternator.
EDITION
2018
... until 2014
-
connection to the engine.
the engine manual.
is not connected to earth.
Page
23