Steering Wires; Replacement - Stiga Park 2WD Workshop Manual

3.2 Steering wires

3.2.1 Replacement

1. Loosen the nuts on the steering wire. Brace
with a spanner so that the wire does not
rotate.
2. Loosen the screws that hold the pulley so
that the wire can be taken out between the
pulley and the wire retainer.
3. Unhook the chain at the front chain sprock-
ets.
It can sometimes be easier to get the chain
off by slightly unscrewing the screws that
hold the chain sprockets.
4. Measure up the middle link (mark A) on the
new chain and mark it.
5. Place the chain on the chain sprockets.
Make sure that the wheel is straight and that
the marked middle link is placed on the mid-
dle of the chain sprocket.
6. Place the wire in the pulley and tighten the
screws to the wire retainers.
7. Fit the washer and nut on the threaded rear
ends of the steering wire.
WORKSHOP MANUAL
PARK
Chapter
3 - Steering
EDITION Page
4
2018
A