Stiga Park 2WD Workshop Manual page 28

4. Measure up the middle link (A) on the new
chain and mark it.
5. Place the chain on the chain sprockets.
Make sure that the wheel is straight and that
the marked middle link (A) is placed on the
middle of the chain sprocket.
6. Place the wire on the chain sprockets and
tighten the screws to the wire retainers.
7. Fit the washer and nut on the threaded rear
ends of the steering chain.
8. Adjust as described below.
Adjustment
1. Tension the nuts equally on both sides so
that the wheel is straight when the machine
is straight.
2. Turn the wheels fully out in both directions.
Check that there is no abnormal noise or
abnormal resistance.
3. Test drive. Check the tension of the chain
after test driving.
WORKSHOP MANUAL
PARK
Chapter
3 - Steering
EDITION Page
6
2018
A