Stiga Park 2WD Workshop Manual page 95

Valid for (
Art. Number)
13-6002-XX 13-6003-XX
13-6104-XX 13-6105-99
13-6111-61 13-6116-XX
Fault
The engine can be started
with the mower deck activated.
The engine does not stop
when the operator leaves the
seat and the mover deck is
activated.
The engine can be started
without the brake pedal
pressed.
The engine does not stop
The starter does not rotate and
there is no "click" heard at the
start attempt.
The starter does not rotate and
there is a "click" heard at the
start attempt.
The starter rotate, but the
engine does not start.
The battery runs repeatedly
empty.
WORKSHOP MANUAL
PARK
13-6004-XX
13-6106-99
-
Cause/Alternative
The engine can be stopped with
the ignition key.
The engine can not be stopped
with the ignition key.
Fault in the safety circuits.
Faulty start engine or start relay
A connected voltmeter to the
battery shows a higher voltage at
high speed than if the engine not is
running.
No voltage different.
Chapter
7 - Electrical System
1005-0073 1005-0105
13-6102-XX 13-6103-XX
13-6107-99 13-6109-XX
-
Action
Adjust or replace the mover deck switch.
1. Adjust or replace the seat switch
2. Adjust/replace the mover deck switch.
Replace the ignition switch.
Replace/adjust the pedal switch.
1. Check the white cable and its
2. Replace the ignition switch.
1. Adjust/replace the pedal switch.
2. Adjust/replace the seat switch.
3. Adjust/replace the mover deck switch.
4. Replace the ignition switch.
5. Replace the start relay.
1. Check cable connections.
2. Replace the start relay.
3. Replace the start engine
1. Check the fuel supply.
2. Check the engine according to
3. Check that the white short circuit cable
4. Replace the ignition switch.
5. Replace the shut off valve.
Replace the battery.
1. Check engine socket connections.
2. Replace the ignition switch.
3. Replace the voltage regulator.
4. Replace the alternator.
EDITION
2018
... until 2014
-
connection to the engine.
the engine manual.
is not connected to earth.
Page
7