Steering Chains; Adjustment - Stiga Park 2WD Workshop Manual

3.2.2 Adjustment

1. Tension the wire nuts equally on both sides
so that the wheel is straight when the
machine is straight.
Brace with a spanner so that the wire does
not twist.
2. Turn the wheels fully out in both directions.
Check that the chain does not go into the
pulley and that the wire does not go into the
chain sprocket.
3. Test drive. Check the tension of the wire
after test driving.

3.2.3 Steering chains

1. Loosen the nuts on the steering chain.
2. Loosen the screws that hold the chain
sprockets so that the chain can be taken out
between the chain sprocket and wire
retainer.
3. Unhook the chain at the front chain
sprockets.
It can be easier to get the chain off by slightly
unscrewing the screws that hold the chain
sprockets.
WORKSHOP MANUAL
PARK
Chapter
3 - Steering
EDITION Page
5
2018