Advertisement
Table of Contents
- 1 Safety System
- 2 Areas of Use
- 3 Starting and Operation
- 4 Checking Transmission Oil Level
- 5 Safety Checks
- 6 Checking the Engine Oil Level
- 7 Operating Tips
- 8 Maintenance
- 9 Tyre Pressure
- 10 Changing Engine Oil
- 11 Belt Transmissions
- 12 Air Filter, Engine
- 13 Spark Plug
- 14 Air Intake
- Download this manual
Advertisement
Table of Contents
Related Manuals for Stiga COMPACT 8211-0001-70
Summary of Contents for Stiga COMPACT 8211-0001-70
- Page 1 BRUKSANVISNING SV ... 6 KÄYTTÖOHJEET FI ... 14 BRUGSANVISNING DA ..22 BRUKSANVISNING NO .30 GEBRAUCHSANWEISUNG DE...38 INSTRUCTIONS FOR USE EN...47 MODE D’EMPLOI FR...56 GEBRUIKSAANWIJZING NL...65 8211-0001-70 S T I G A P A R K C O M P A C T C O M P A C T H S T C O M P A C T 4 W D...
- Page 3 05_119...
- Page 6 1 GENERAL This symbol indicates WARNING. Seri- ous personal injury and/or damage to property may result if the instructions are not followed carefully. You must read these instructions for use and the accompanying pamphlet “SAFETY INSTRUCTIONS” careful- ly, before starting up the machine. 1.1 SYMBOLS The following symbols appear on the machine.
-
Page 7: Safety System
The articulated steering means that the machine can turn around trees and other obstacles with an extremely small turning radius. 2.3 Safety system The machine is equipped with an electrical safety system. The safety system interrupts certain activ- ities that can entail a danger of incorrect manoeu- vres. - Page 8 2.4.7 Ignition lock (1:E) Do not leave the machine with the key in position 2 or 3. There is a fire risk, fuel can run into the engine through the carburettor, and there is a risk of the battery being discharged and damaged. Ignition lock used for starting/stopping the engine.
-
Page 9: Areas Of Use
3 AREAS OF USE The machine may only be used for the following tasks using the genuine STIGA accessories stated. Operation Accessories, STIGA original Mowing With cutting deck 95 C (all). With cutting deck 105 C (only HST with 15.5 hp engine and 4WD). -
Page 10: Operating Tips
4.4.1 General safety check Object Result Fuel lines and con- No leaks. nections. Electrical cables. All insulation intact. No mechanical damage. Exhaust system. No leaks at connections. All screws tightened. Oil lines No leaks. No damage. Drive the machine The machine will stop. forwards/back- wards and release the driving-service... -
Page 11: Maintenance
5.1 Service programme In order to keep the machine in good condition as regards reliability and operational safety as well as from an environmental perspective, STIGA’s Ser- vice programme should be followed. The contents of this programme can be found in the attached service log. -
Page 12: Belt Transmissions
5.5 Transmission, oil (4WD) The oil in the hydraulic power transmission must be checked/adjusted and changed at the intervals given in the table below. 1st time Then at Action Hours of operation Checking – adjusting level. Changing the oil. Type of oil: Synthetic oil 5W-50 Oil quantity when changing: approximately 3.5 li- tres. -
Page 13: Air Filter, Engine
5.7 Steering The steering must be checked/adjusted after 5 hours of operation and thereafter after 100 hours of operation. 5.7.1 Checks Briefly turn the steering wheel back and forth. There must be no mechanical clearance in the steering chains. 5.7.2 Adjustment Adjust the steering chains if required as follows: 1. -
Page 14: Spark Plug
4. Clean the paper filter by tapping it gently against a flat surface. If the filter is very dirty, replace it. 5. Clean the pre-filter. If the filter is very dirty, re- place it. 6. Assemble in the reverse order. Compressed air or petroleum-based solvents such as kerosene may not be used for cleaning the paper filter insert. - Page 15 w w w. s t i g a . c o m GGP Sweden AB · Box 1006 · SE-573 28 T RANÅ S...