Repair And Replacements; Replacement Of Switches; Replacement Of Switch Knob - Stiga Park 2WD Workshop Manual

7.3 Repair and replacements

Warning
Do not wear rings, metallic bracelet,
chain round the neck or similar metal
objects when working with the electri-
cal system. It can cause short-circuit,
burns and fire.

7.3.1 Replacement of switches

All switches are pressed into place in their
rectangular holes at the control panel. To
change a switch proceed as follows:
1. Remove the actual cover to get access to the
switch.
2. Press the fixation pig at the connector and pull
the connector from the switch.
See the figure.
Some connectors have 2 pigs.
3. Press the fixation tongues on both sides of the
switch against the switch. Use a screwdriver
or similar and work up the switch.
See the figure.

7.3.2 Replacement of switch knob

To replace the switch knob, there is a special
tool available. Regarding reference number,
see the spare parts list
Remove the knob by pushing in the tool
backwards and press until the knob jumps up.
The knob is easily assembled by pressing it
down in its hole in the switch.
WORKSHOP MANUAL
PARK
Chapter
7 - Electrical System
EDITION Page
44
2018