Verification Of The Installation Requirements; Garden Verification; Charging Base And Power Supply Installation Checks - Stiga G 300 Instruction Manual

4.3.

VERIFICATION OF THE INSTALLATION REQUIREMENTS

Below, the procedures to check the necessary requirements and prepare the garden before proceeding
with the installation are described.

4.3.1. GARDEN VERIFICATION:

• Carry out a survey of the entire area for a correct detection of the state of the garden, of any
obstacles and areas to be excluded.
• Check that the lawn to be mowed is uniform, free of holes, stones or other obstacles and, if
necessary, carry out the appropriate environmental decontamination works.
NOTE: Level the ground to prevent puddles from forming after a rainfall.
NOTE: At the first installation, the initial height of the grass must be within the operating range
of the robot lawn mower: 20-60mm. If necessary, prepare the garden using a traditional lawn
mower.

4.3.2. CHARGING BASE AND POWER SUPPLY INSTALLATION CHECKS

ELECTRICAL HAZARD:
A socket must have been prepared
near the installation area to connect
it to electricity. Make sure that
connection to the power supply
network conforms to laws in force of
the Country where it is used.
ELECTRICAL HAZARD:
The circuit provided must be protected
by a residual current device (RCD)
with an activation current not
exceeding 30 mA.
Procedure:
1. Prepare a flat area at the edge of the lawn for positioning the charging base (A), preferably in the
largest portion of the garden and near an electrical outlet.
2. Make sure there is enough space to install the charging base on a straight section of the perimeter
cable (B), so that the distance of the base from any curves is at least X = 200 cm; the ground must
be perfectly flat and compact in order to avoid the deformation of the surface of the charging base.
EN
C
B
ELECTRICAL HAZARD:
Do not connect the power supply to
an electrical outlet if the plug or the
cable is damaged.
Do not connect or touch a damaged
cable before it is disconnected from
the power supply.
A damaged cable can lead to
contact with live parts.
A
4. INSTALLATION
17