Stiga Park 2WD Workshop Manual page 86

3. Adjust at the wire adjusting sleeves until the
space (A) between the tension pulley and
motor pulley coincide with the table below:
Machine
2WD machines with the con-
trol panel to the right of the
operator, e.g. Comfort, Roy-
al, Senator etc.
4WD machines with the con-
trol panel to the right of the
operator, e.g. Comfort, Roy-
al, Senator etc.
Compact
Warning!
It is important that the movement of
the tensioning arm is always
stopped by the brake pad, and not
by the engagement wire. If the wire
stops the movement, the braking ca-
pacity can be completely lost when
the parts become worn.
4. Press the brake shoe hard against the pul-
ley.
In this position, 1/4 of the hole shall be visi-
ble when the nipple is compared with its
hole.
WORKSHOP MANUAL
PARK
Measure (A)
30 mm
35 mm
20 mm
Chapter
6 - Control Wires
1/4 Dia.
EDITION Page
19
2018