Final Checks - Stiga Titan Series Workshop Manual

1.4.3 Final checks

Actions before starting
Carry out the following before starting the
machine:
• Check/top up with fuel.
• Check/adjust the engine oil level.
• Check/adjust the coolant level.
• Check to make sure that the air filter
indicator has not been tripped.
• Check that the water separator and fuel
filter taps are open.
• Check that the water separator does
not contain water. Drain if necessary.
• Check the oil level in the hydraulic tank.
The oil level is visible in the sight glass.
• Carry out safety checks.
• Check that the disengagement lever is
in the inner position. Refer to the
machine's instructions for use.
• Check that the distance from the centre
of the wheel to the ground is the same
for all 4 wheels. If not adjust the air
pressure. See image below.
WORKSHOP MANUAL
TITAN
Chapter
1 - General instructions
Test driving
Run the engine to operating temperature
at idle speed before test driving. For more
in-depth instructions see "6.8" in the in-
structions for use. Run the machine for a
few minutes. Test all functions. Check in
particular that the safety equipment func-
tions. If the machine is to be supplied with
a cutting deck or other equipment, this
equipment must be installed before test
driving the machine.
EDITION Page
2018 7