Wiring Diagram - Delta DVP02TK-S Manual

D V P02 T K-S / D VP 02 TU - S Te mp er ature C on tr ol Mod ul e M an ua l

Mounting Arrangements and Wiring Notes
How to install DIN rail
DVP-PLC can be secured to a cabinet by using the DIN rail of 35mm in height and
7.5mm in depth. When mounting PLC to DIN rail, be sure to use the end bracket to
stop any side-to-side movement of PLC and reduce the chance of wires being
loosen. A small retaining clip is at the bottom of PLC. To secure PLC to DIN rail,
_1
place the clip onto the rail and gently push it up. To remove it, pull the retaining clip
down and gently remove PLC from DIN rail, as shown in the figure.
Please install PLC in an enclosure with sufficient space around it to allow heat dissipation as shown in the figure.
D
D D
DVP
MP
D
D > 50 mm
Warning: shock hazard. Only for mounting in a rack or enclosure fully enclosing all live parts.
Avertissement : risque d'électrocution. Ne doit être installé que dans un bâti ou un boîtier recouvrant entièrement toutes
les pièces sous tension.

1.5 Wiring Diagram

22-16AWG
< 1.5mm
1. Use 22-16AWG (1.5mm) single or multiple core wire on I/O wiring terminals. The specification of the terminal is
shown in the figure above. The PLC terminal screws shall be tightened to 1.95 kg-cm (1.7 in-lbs).
2. DO NOT place the I/O signal wires and power supply wire in the same wiring duct.
3. Warning: use conductors with insulation rated for at least 75 °c
Avertissement : employer des conducteurs pour au moins 75 °c.
4. For use with copper conductors only (excluding thermocouplers).
destiné à être utilisé avec des conducteurs en cuivre seulement (sauf thermocouples).
1 - 1 0