Factory Settings; Loop Processor Card (Lpc) - Honeywell Gent Viglion EN54 Generic Commissioning Instructions

Factory settings

The factory settings of the panel are described here.
P0 - RS485, Baud: 1200 Mode: Repeat
(dedicated for repeat indicator panel)
P1 - RS232, Baud: 9600, Mode: Standard
P2 - RS485, Baud: 9600, Mode: Standard
NVM - software write allowed (NVM protect -disabled)
hardware write allowed (NVM protect -disabled)
NVM hardware link P13
Master Control Board
P6
P15 P10 P11
24V
FS3 200mA
P1 CARD 2
BATT1
CODE BCKUP
IC16
IC3
P16
' Hardware' NVM protect link P13
Factory setting is NVM protect
disabled
NVM protect - [disabled]
(ie NVM unprotected,
that is write allowed
NVM protect - [Enabled]
(ie NVM protected,
that is write not allowed
System configuration
Domain address - 0
Panel (Node) address - 1
All devices assigned to sector 1
All devices assigned to zone 1
Sector 1 is assigned to all ten voice alarm zones
4188-856_i2_12/06_Generic Vigilon (Compact + VA) Comms.
P7
P14 P9 P8
MA2 - FS2 250mA
MA1 - FS1 250mA
P2 CARD 1
Loop Card
POWER
SUPPLY
P12
SW1
P13
)
)
Vigilon (EN & BS) Compact (VA) panels

Loop Processor Card (LPC)

A Loop Processor Card (part number : COMPACT-LPC) is able
to control up to 200 devices connected onto a loop circuit. The
LPC drives the loop circuit from both ends, and handles all
messages to and from each device. The control panel can
accommodate up to 2 LPCs.
Connector P1 Plugs into the MCB
Local Processor Card
¨
Fit the Loop Processor Card in Card 1/2 slot on the
MCB.
IC4 Loop
Processor
35