Remove The Protective Covers; Fitting The Inner Door - Honeywell Gent Viglion EN54 Generic Commissioning Instructions

Remove the protective covers

PSU Cardboard cover
Remove the cardboard protection cover fitted over the PSU. The cover is held in by a retaining clip.
Backplane transparent cover
Remove the transparent protection cover fitted over the backplane.

Fitting the inner door

Locate the hinge pints on the inner door assembly into the two hinge pin holes j on the backbox outer face.
Fit the earth lead from the backbox to the inner door spade connector k.
Fit together the two blue connectors of the printer 0V leadsl, the leads are located at the inner door and backbox intersection.
Masking tape
Inner door
Danger
WARNING
REMOVAL OF COVER
EXPOSES HIGH V H VOLTAGES
4188-856_i2_12/06_Generic Vigilon (Compact + VA) Comms.
Vigilon (EN & BS) Compact (VA) panels
locating
Inner
the hinge pin
door
Backbox
Earth spade
for connection from
backbox
Preformed ribbon
cables held together
under masking tape
to be fitted during
commissioning
Card guide
Transit position of
printer paper roll
and holder pin held
together with an elasticband
Connector for
printer 0V
Paper roll
holder bracket
Hinge point
Cables of external circuits
Earth to
inner door
Transparent
cover over
backplane
Printer 0V
BACKBOX (Part view)
17