Table of Contents
Advertisement
[:CGRoup(*)]:MODule(*):CONNector(*) Subsystem
Parameters
Return Value
Parameters
Agilent 81250 Parallel Bit Error Ratio Tester, Programming Reference, March 2006
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:<Handle>[:CGRoup(*)]:MODule(*):
CONNector(*):CALibration:CDELay
Syntax
:<Handle>[:CGRoup(*)]:MODule(*):CONNector(*):CALibration:CDELay <Cable
Delay>
<NRf>
Cable Delay value.
Sets a cable delay for the specified connector to synchronize it with
other signals applied to the DUT terminals.
NOT E
Delay Auto Calibration must be performed before the cable delay can
be set.
Example
:_test:MOD1:CONN1:CAL:CDEL 6.5e-9
:<Handle>[:CGRoup(*)]:MODule(*):
CONNector(*):CALibration:CDELay?
Syntax
:<Handle>[:CGRoup(*)]:MODule(*):CONNector(*):CALibration:CDELay?
Returns the current cable delay for the specified connector of the
specified module.
Example
:_test:MOD1:CONN1:CAL:CDEL?
might return:
6.500000E-009
:<Handle>[:CGRoup(*)]:MODule(*):
CONNector(*):CALibration:ZDELay
Syntax
:<Handle>[:CGRoup(*)]:MODule(*):CONNector(*):CALibration:ZDELay
<Zero Delay>
Sets a zero delay for the specified connector of the specified module.
<Zero Delay>
NOT E
Delay Auto Calibration must be executed before zero delay can be set.
Commands in DSR Application Subsystems
Zero delay value.
131
Advertisement
Table of Contents
