Agilent Technologies 81250 System Programming Manual And Scpi Reference page 164

:SGENeral:GLOBal:SEQuence Subsystem
Range/Value Coupling
Reset Value
Description:
Agilent 81250 Parallel Bit Error Ratio Tester, Programming Reference, March 2006
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The events defined here are used by the sequence expression.
The expression is just stored and not checked. The expression is
evaluated under two conditions:
• An SGEN:GLOB:SEQ:FORC command is executed.
• An SGEN:GLOB:INIT:CONT ON command is executed and the
sequence expression is changed, or another parameter is changed
that requires a new sequence / data download.
Therefore, syntax errors within the expression or range violations are
detected only after these conditions.
The values possible for the Error events depend on the receive mode
used. In Capture Mode the error events are simply ignored.
Deleting a port results in an error event (invalid port). Therefore, the
event-expression is automatically adjusted to remove this error event.
As reset value all 10 events are disabled:
(3.0,(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))))
Limits
The specified events must be unique. The events to be used must be
unambiguous.
With this command the events are defined for the system. The event
expression corresponds to the Event Editor of the graphical user
interface.
Example
sgen:glob:seq:even (2.0,(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))),
(,0,(('x','xxxxxxxx','xx',IGNORE))))
Commands in DSR Application Subsystems
163