Installation; Surface Mounting - Nortel BayStack 350 Series Manual

Installation

This section explains how to install, power up, and verify the operation of the
BayStack 350 switch. Before you begin these procedures, read and follow the
instructions in
Warning: To avoid bodily injury from hazardous electrical current, do not
connect the power cord until instructed to do so.
You can install the BayStack 350 switch in any of the following locations:
•
•

Surface Mounting

You can mount the BayStack 350 switch on any surface that can safely support the
weight of the switch and attached cables, as long as there is adequate space around
the unit for ventilation and access to cable connectors. You can use the mounting
brackets supplied with the switch (Model 350F and Model 350T only) to secure it
to the installation location.
Note: In most cases, it is not necessary to secure the BayStack 350 switch to a
table or shelf. However, if conditions warrant securing the switch (for
example, in locations where the switch might accidentally fall from a shelf or
overhead location), you can secure the switch using two mounting brackets
(Model 350F and Model 350T only).
893-00992-E
"Site Preparation" on
Surface mounting:
-- Table or shelf (secured or unsecured)
-- Wall (Model 350F and Model 350T only)
Rack mounting:
-- Standard equipment rack
Installing the BayStack 350 Switch
page 2-3.
2-5