Using The Ci Menus And Screens - Nortel BayStack 350 Series Manual

Using the BayStack 350 Series 10/100 Autosense Switch
To access the CI menus and screens, follow these steps:
Turn on the console terminal, or make sure that your PC is running in
1.
terminal-emulation mode.
Set the console terminal configuration parameters as follows:
2.
•
•
•
•
Set the console terminal to online mode; do not leave it in setup mode.
3.
Press [Ctrl]+C on the console terminal keyboard.
4.
The CI main menu opens (see
the main menu, proceed to the next section,
Screens."

Using the CI Menus and Screens

The CI menus and screens provide commands that allow you to configure and
manage the BayStack 350 switch. Help prompts at the bottom of each menu and
screen explain how to enter data in the highlighted field and how to navigate the
menus and screens.
Although some commands take effect immediately, other commands are followed
by an ellipsis (for example, IP Configuration...), indicating that there is a submenu
with other options.
Some commands allow you to toggle between several possible settings; other
commands allow you to set or modify a parameter.
3-4
9600 baud
8 data bits
No parity
1 stop bit
Figure 3-2). For more information about using
"Using the CI Menus and
893-00992-E