Installing The Baystack 350 Switch; Required Tools And Materials - Nortel BayStack 350 Series Manual

This chapter explains how to install the BayStack 350 switch. The switch can be
placed on a table or shelf, mounted on a wall, or installed in a standard 19-inch
equipment rack.
To install the BayStack 350 switch, you unpack the equipment, physically install
the switch, connect the network cables, connect the power, and then verify the
installation.

Required Tools and Materials

You will need the following tools to install the BayStack 350 switch:
•
•
Caution: The screws and wall composition must be able to withstand the
weight of the device, plus the additional weight of the attached network cables
and power cords.
893-00992-E

Installing the BayStack 350 Switch

For installation in an equipment rack, use a Phillips or crosshead screwdriver.
For wall mounting, you need four screws (not supplied). The screw size and
type depends on the composition of the wall on which you intend to mount the
switch. Have an experienced maintenance person choose the appropriate
hardware for your wall composition.
Chapter 2
2-1