Setting Security Passwords - Nortel BayStack 350 Series Manual

Using the BayStack 350 Series 10/100 Autosense Switch
Table 3-22. Console/Service Port Configuration screen fields
Field

Setting Security Passwords

Setting security passwords for your switch requires setting the appropriate
parameter values in two screens:
• Console Service Port Configuration screen
• Radius Network Security screen
This section provides a matrix you can use to determine the proper values to enter
according to your security requirements. To use the matrix, do the following:
Determine your console security requirements
1.
Table 3-23.
Security requirement:
Console
1 C = Console, L = Local, N = None, R = RADIUS.
Determine your TELNET sessions security requirements
2.
Table 3-24.
Security requirement:
TELNET
1 L = Local, N = None, R = RADIUS, T = TELNET.
3-60
Description
Caution:
If you change the system-supplied default passwords, be sure to
write the new passwords down and keep them in a safe place. If you forget the
new passwords, you cannot access the console interface. In that case, contact
Nortel Networks for help.
Default secure
Range Any ASCII string of up to 15 printable characters
Determining Console Security Requirements
Determining TELNET Sessions Security Requirements
(continued)
(page 3-58)
(page 3-77)
(Table
Choose one of the following values
None Local
(CN) (CL)
Choose one of the following values
None Local
(TN) (TL)
3-23).
:
1
RADIUS
(CR)
(Table 3-24).
:
1
RADIUS
(TR)
893-00992-E