Adding Custom Words - ADEMCO via30 Installation Instructions Manual

4. For selection of the next word (e.g., DOOR), repeat steps 3a or 3b. For 3b,
press key [3] until the first letter of the next word appears (e.g., "'D). Then
press [6] to display the first available word beginning with that letter (e.g.
DAUGHTERS). Press [3] repeatedly until the desired word (e.g., DOOR) ap-
pears. To accept the word, press [6], which toggles back to the alphabet list.
5. When all desired words have been entered, press [8] to store the description
in memory.
6. /n fie/d *56, the next zone number in sequence will now be displayed for
corryiete zone information entry.
/n field *82, enter ~][N][N], where NN is the next zone that you want to review
or for which you want to program a descriptor. To modify the descriptor, enter
~][N][N] again. To exit this mode, press ~][o][o].
Adding Custom Words Up to five installer-defined words can be added to the built-in vocabulary. Each of
the five "words" can actually consist of a "word string" of severs/words, but no
more than ten characters can be
used
for each word or word string.
1. Select CUSTOM WORD mode when the question arises.
The console keys perform the following functions:
[3] Advances through alphabet in ascending order.
[1] Moves through alphabet in descending order.
[6] Selects desired letter; moves cursor one space to right.
[4] Moves cursor one space to left.
[7] Inserts a space
at
the cursor location, erasing any character located there,
[8] Saves the new word in the system's memory.
2. Key the number ([1l-[5]) of the custom
word or word string to be created (for
example, if you are creating the first custom word or word-string, enter [1], for
the second, enter [2], etc.). A cursor will now appear at the beginning of the
second line.
3. One of two methods of entering the custom word's characters
can now be used (refer to the CHARACTER LIST of letters, numbers, and
symbols on the next page):
Important: Custom words must begin with an alphabetic character. If a
number or symbol is used as the first character, the word will
not be saved.
a) Press the [#] key, followed by the two digit entry for the first
letter you would like to display (e.g., [6][5] for "A), or...
b) Use the [3] key to advance through the list of symbols,
numbers, and letters. Use the [1] key to move back through the list.
4. When you have reached the desired character,
press [6] to select it. The cur-
sor will then move to the right, in position for the next character.
5. Repeat steps 3 and 4 to crest the desired word(s). Note that the [4] key can
be used to move the cursor to the left, if necessary, and that key [7] can be
used to enter a blank (or erase an existing character). Remember, no word or
word-string can exceed 10 characters.
6. Press the [8] key to save the custom word(s) and return to the "CUSTOM ?'
display. Repeat steps 2-5 for other custom words to be entered. To change a
custom word, just overwrite it. If no more are to be entered now, press [0] to
return to the Descriptor entry. The custom word(s) will be automatically added
to the built-in vocabulary.
When zone descriptors are being entered as described in step 3a of the Entering
Zone Descriptors section, the custom word numbers are 250 to 254 for words 1
to 5 respectively. When being entered as described in step 3b of that section,
each word will be found at the end of the group of words that begin with the same
letter as it does.
-31-