Power-Up Procedure - ADEMCO via30 Installation Instructions Manual

Power-up Procedure
1.
Make sure that the total current to be drawn from the Alarm Output terminals
(3 & 4) and Auxiliary Power Output terminals (4 &5) does not exceed the
values indicated in the SPEC/F/CAT/ONS section and on the SUMMARY OF
CONNECTIONS diagram.
2. Wire the transformer to the panel (before connecting the battery) as shown
on the SUMMARY OF CONNECTIONS diagram. Do not plug in at this
time.
3. Connect all ioops, devices, consoles, etc. to the panel.
4. Piug the transformer into a 24 hour, uninterrupted AC outlet. After some ini-
tial displays (see page 22) and approximately one minute, the green POWER
or READY LED on the consoie(s)
should be lit and the consoles should dis-
play "READV (Fixed Word consoles) or "DiSARMED READY TO ARM"
(Alpha consoles).
5. Connect the battery as shown in the SUMMARY OF CONNECTIONS
diagram.
-17-