Alpha Description; Assigning Zone Descriptors; Entering Zone Descriptors - ADEMCO via30 Installation Instructions Manual

*96
INITIALIZE DOWNLOAD ID AND SUBSCRIBER ACCT. No.
FOR DOWNLOADING
(No data entry required, loads defaults)
*97 SET ALL PROGRAM FIELDS TO DEFAULT VALUES
(No data entry required)
TO EXIT
lPress *98 or *99 if exiting programming, or next Field No. if continuing,
PROGRAMMING MODE
(*98 Or *99) *98
EXITS PROGRAMMING MODE
and prevents re-ent~ by:
ALPHA
Master Code + CODE + O
99 EXITS PROGRAMMING MODE
and a//owsre-entryby:
Master Code + CODE + O
or by:
Power-up + "*" + "#".
DESCRIPTION ENTRIES
lSee the ALPHA FIXED DICTIONARY and CHARACTER CHART on page 32. {
Assigning
The 5137 Console used
with the Adefr?co
via30 can
have a user-friendly
En-
Zone Descriptors glish language description/location of all protection zones, keypad panics, and RF
receiver supervision faults programmed into the system. Each description can be
composed of a combination of words (up to a maximum of 3) selected from a vo-
cabulary of 244 words stored in memory (see page 32). In addition, up to 5 in-
staller-defined words can be added to those already in memory. Thus, when an
alarm or trouble occurs in a zone, an appropriate description for that zone's loca-
tion will be displayed at the console.
Note: Alpha Descriptor entry can be done locally at the5137 Console or re-
motely using a 4130 PC Downloader. The 5137 procedure is described
below.
Entering 1.
The descriptor can be entered when the zone is being defined in field 56 c
Zone Descriptors
it
can be entered later, in field 82.
The console keys perform the following functions:
[3] Scrolls both alphabet and actual words in ascending alphabetical order.
[1] Scrolls both alphabet and actual words in descending alphabetical order.
[6] Toggles between alphabet and actual word list; used to accept entries.
[8] Saves the zone description in the system's memory.
2. Key ~][0][1 ] to begin entering the description for zone 1 (key ~][0][2] for
zone 2, ~][0][3] for zone 3, etc.). /f nothing was entered previously,
the
fol-
lowing will be displayed:
~
Note that the first letter of the alphabet appears after the zone number, and
that the zone number is automatically included with the description. // there
a/ready is a description for the zone, the description will appear (with no cur-
sor, since this is a display mode). If if is desired to enter or change a descrip-
tion, key in ~] + Zone Number again, A flashing cursor will now appear.
3. One of two methods of entering the words can now be used
(assume, for example that the desired descr@tion for zone 1 is BACK DOOR):
a) Press [#] followed by the 3 digit number of the first word
from the fixed dictionary shown on page 32 (e.g., [0][1][3] for
BACK). Press [6] in order to save the word and proceed, or...
b) Select the first letter of the desired description (note that "A
is already displayed). Press key [3] repeatedlyto advance throughthe al-
phabet (e.g., to "B"),or key [1] to go backward. Then press [6] to display
the first available word beginning with the desired letter (e.g., BABY).
Next, press [3] repeatedlyto move forward, or [1] to move backward, until
the desired word is displayed (e.g., BACK). Then press [6] to accept th~
word and toggle back to the alphabet list.
-30-