ADEMCO via30 Installation Instructions Manual page 26

Custom Alpha Editing
For all zone types, the next request is to enter alpha descriptors for the
zones. The entry may be done now or may be done at a later time via field
82.
~ See the ALPHA DESCRIPTION ENTRIES section on page 30. ~
When all entries to be made for the zone at this time are complete, the next zone
number can be entered for programming, or zone programming can be ended by
entering [0][0] as the next "zone number".
Notes:
.
.
.
When using a 5801, the Function
"4"
button should always be used and
learned by the system.
M t7e/d 56, at the summary line for each zone, the entered values can be
checked. If it is desired to change anything, press [#] to move to the previous
entry. Press [#] a number of times to move to earlier entries. Press ~] to move
to later entries again.
Zone entries can be reviewed by pressing [#][5][6]. Changes cannot be made
here, so this is safer for review. Enter the first zone number to be viewed and
press [#]. To view each zone, press [#] and the zone number will advance to
the next programmed zone. When the end of the list is reached, press [0][0] to
exit. This method of exiting may also be done at any time during the review.
To either temporafi/y or permanent/y remove a zone from the system, go into
programming mode and press ~][5][6]. Enter the zone number and press ~]. At
the Zone Type prompt, enter [0][0] and [*]. This sets the type of the zone to
Not Used. The next prompt will be "Delete Zone?'. "Yes" will permanently re-
move the zone from the system while "No" will disable it but retain all data ex-
cept the original zone type. You can then go back to this zone later and put back
an active Zone Type to re-enable it.
An /0 code that has been /earned for a 5800 system wi// not be deleted if the
zone is disabled as described above. If only the physics/transmitter is to be re-
moved or changed (i.e., its ID code deleted), it can be done in field *56 or 83.
In programming mode, press ["][5][6], enter the zone number, and press ~] ~
multiple times until the cursor is under the Learned RF Input (L) position. This is
the specific loop or button on the transmitter that has been learned for that
zone. If a [0] is entered at Ibis point, a prompt "De!ete S/N?" will appear. If "Yes"
is entered, this specific ID code will be deleted from the system.
–26–
(continued on page
27)