Sony PDW-R1 Operation Manual page 95

Display in video panel and on external monitor
Cursor indicating the currently selected sub-item
BLANK LINE SELECT
* ALL LINE
LINE 12
Display in time data display
Sub-item number (flashing while changing)
4
With the SHUTTLE button held down, rotate the jog
dial or shuttle dial to change the setting.
The displays in the video panel, on an external
monitor, and in the time data display section change as
shown below when you hold down the SHUTTLE
button. In the time data display section, the currently
selected setting value flashes to indicate that you can
change it to another value.
Display in video panel and on external monitor
Setting value
ITEM-001
PREROLL TIME
Display in time data display
Setting value (flashing while changing)
5
Press the SET button.
This saves the new setting value, and the menu display
disappears from the video panel, the external monitor,
and the time data display section.
ITEM-703
- ---
- blnk
5 sec
To abandon making a change
Press the MENU button before pressing the SET
button.
The menu display disappears from the video panel, the
external monitor, and the time data display section
without the new setting value being saved.
Resetting the menu settings to their
factory default values
To reset the current active menu settings to their factory
default values, proceed as follows.
1
KEY INHI TC COUNTER
ON SEL HOLD
INT PRESET F-RUN
NETWORK
LOCAL EXT
ACCESS REMOTE RP188 REGEN R-RUN
OFF
ALL/CH-1 CH-2 CH-3 CH-4
METER MONITOR
VARIABLE
SEL SEL
REC
PRESET
PB
L/ST/R
AUDIO
PREV PLAY NEXT STOP REC
TOP F REV F FWD END
1
Press the MENU button.
The menu appears in the video panel, on an external
monitor to which the output of the VIDEO OUT 2
(SUPER)/SDI OUT (SUPER) connector is input, and
in the time data display section.
2
Press the RESET button.
The message "INITIALIZE ALL ITEMS TO
FACTORY PRESET VALUES?" appears in the video
panel and on the external monitor.
The message "Init setup?" appears in the time data
display.
To abandon operations and return to the setup
menu display
Press the RESET button again.
3
Press the SET button.
The menu settings are reset to their factory default
settings.
Switching between 525(U) line, 525(J) line
and 625 line modes (menu item 013)
To switch between 525(U) line, 525(J) line and 625 line
operation modes, proceed as follows.
1
Press the MENU button.
2
Turn the jog dial or shuttle dial to display menu item
013 in the time data display.
3 2
SHUTTLE JOG
SUB THUMB
CLIP NAIL SHIFT
CLIP
ESSENCE
MENU
MARK
MENU SET RESET
SYSTEM S.SEL
MENU
MARK1
IN OUT
MARK2
7-2 Basic Setup Menu
95