Sony PDW-R1 Operation Manual page 26

71.
For information about how to use the software, refer to the
Help provided in the software.
Using the (network) connector (FTP
connection)
The following shows an example of an FTP (File Transfer
Protocol) connection.
Note
To use PDZ-1 requires the PDW-R1 IP address and other
network-related settings to be made beforehand.
For details of the network-related settings, see "To change
network settings" (page 115).
Connecting this unit directly to a laptop computer
1: Network cable (not supplied)
REMOTE
DC OUT 12V
VIDEO
S400
IN OUT1
(network) connector
1
To network connector
Make sure the remote control switch (see page 12) is set to
"NETWORK" and extended menu item 257 "NETWORK
ENABLE" is set to "net."
a) Use a cross cable.
26
3-1 Connections and Settings
a)
PDW-R1
AUDIO IN
1/3 2/4
REF VIDEO IN DIGITAL AUDIO (AES/EBU)
IN 1/2 3/4 OUT 1/2 3/4
AUDIO OUT
SDI TC
1/3 2/4
OUT2(SUPER) IN OUT(SUPER) IN OUT
Laptop computer
Connecting three PDW-R1 units to a laptop computer via a
LAN.
1: Network cable (not supplied)
PDW-R1
(network) connector
PDW-R1
(network) connector
Laptop computer
Make sure the remote control switch (see page 12) is set to
"NETWORK" on each of the three PDW-R1 units and extended
menu item 257 "NETWORK ENABLE" is set to "net."
a) Use a straight cable.
Using the S400 (i.LINK) connector (FAM
connection)
The following shows an example of a FAM (file access
mode) connection.
Note
The PDZ-1 Proxy Browsing Software must be installed in
advance.
The required FAM driver is also installed when you install
the PDZ-1 software.
See 5-4 "Using PDZ-1 Proxy Browsing Software" (page
71) for more information about installing the PDZ-1
software.
Some limitations apply to FAM connections. For details,
see 6-2 "File Access Mode File Operations" (page 78).
a)
PDW-R1
(network) connector
1
1
1
LAN
1
To network connector