Sony PDW-R1 Operation Manual page 115

4
Press the g button.
A lower-level menu (setting modification screen)
appears. The current setting is highlighted, and the
arrow (C) flashes to indicate that you can move to a
higher-level menu. If the current setting is the factory
default, a colon (:) appears between the item name and
the setting. A midpoint (•) appears if you change the
factory default setting to another value and then
display the setting modification screen again.
Setting modification screen
Flashes
MAINTENANCE MENU
NETWORK CONFIG
DHCP
T * DISABLE
ENABLE
Indicates that the current setting is
the factory default (change to "•" if
the default setting is changed)
Indicates a factory default setting
To return to the menu item
Press the G button.
When there is a sub-item
Repeat steps 3 and 4 until the setting modification
screen appears.
5
Using the F/f buttons to select the desired setting.
6
Press the SET button.
This saves the new setting, and the menu disappears
from the video panel or an external monitor.
To cancel changing a setting
Before pressing the SET button, press the MENU
button.
The menu disappears from the video panel or an
external monitor, without saving the new setting.
To change network settings
To change network settings, carry out steps 1 to 3 in the
procedure of "Basic maintenance menu operations" above,
to display the NETWORK CONFIG menu item, then carry
out the following operations.
For details of the settings, consult your network
administrator.
When the IP address is assigned automatically
Check that the network cable is connected to this unit
before carrying out the operation.
: dis
1
2
3
Current setting
4
To set the IP address
First set DHCP to "DISABLE." (See the previous item,
"When the IP address is assigned automatically.")
SUB THUMB
KEY INHI TC COUNTER
CLIP NAIL
ON SEL HOLD
NETWORK INT PRESET F-RUN
LOCAL EXT
ACCESS REMOTE
RP188 REGEN R-RUN
OFF
CLIP ESSENCE
MENU MARK
ALL/CH-1 CH-2 CH-3 CH-4
METER MONITOR
VARIABLE MENU SET
SEL SEL
REC
PRESET
PB
L/ST/R
SYSTEM
S.SEL
AUDIO
MENU
MARK1
PREV PLAY NEXT STOP REC
IN
F REV F FWD
TOP END
MARK2
1,3
Using the F/f buttons to select "DHCP."
Press the g button.
Press the f button to select "ENABLE."
Press the SET button.
To check the assigned IP address
In the NETWORK CONFIG menu, using the F/f
buttons to select "IP ADDRESS," then press the g
button.
Note
If the IP address cannot be assigned, this is shown as
"000.000.000.000." In this case, consult the network
administrator.
7 4,6
SUB THUMB
KEY INHI TC COUNTER
CLIP NAIL
ON SEL HOLD
NETWORK INT PRESET F-RUN
LOCAL EXT
ACCESS REMOTE
RP188 REGEN R-RUN
OFF
CLIP ESSENCE
MENU MARK
ALL/CH-1 CH-2 CH-3 CH-4
METER MONITOR
VARIABLE MENU SET
SEL SEL
REC
PRESET
PB
L/ST/R
SYSTEM
S.SEL
AUDIO
MENU
MARK1
PREV PLAY NEXT STOP REC
IN
F REV F FWD
TOP END
MARK2
1,3
4
SHUTTLE JOG
SHIFT
RESET
OUT
2
3
SHUTTLE JOG
SHIFT
RESET
OUT
2,3
7-4 Maintenance Menu
115