Basic Menu Operations - Sony PDW-R1 Operation Manual

7-2-2 Basic Menu Operations

Basic setup menu operations
This section explains how to select setup menu items and
how to change their values. The operations are common to
both the basic menu and the extended menu.
Time data display
DATA DATA DATA DATA
VITC VIUB COUNTER HOLD
dB OVER dB OVER dB OVER dB OVER
0 0 0 0
PB NDF EXT-LK
-12 -12 -12 -12
-20 -20 -20 -20
HOURS MINUTES SECONDS
-30 -30 -30 -30
-40 -40 -40 -40
DISC E
-60 -60 -60 -60
CH- 15 CH- 26 CH- 37 CH- 48 BATT E
PROCESS
AUDIO CONTROL
VIDEO
INPUT SEL
INPUT CH INPUT SEL STATUS CHARACTER
WARNING KEY INHI REC INHI
OFF ON
1,5
KEY INHI TC
ON
INT PRESET F-RUN
NETWORK
LOCAL EXT
ACCESS REMOTE
OFF RP188 REGEN R-RUN
ALL/CH-1 CH-2 CH-3 CH-4
VARIABLE
REC
PRESET
PB
AUDIO
PREV PLAY NEXT STOP
F REV F FWD
TOP END
3
NEXT button
1
Press the MENU button.
The setup menu appears in the video panel, and on an
external monitor to which the output of the VIDEO
OUT 2 (SUPER)/SDI OUT (SUPER) connector is
input. A cursor indicates the currently selected menu
item.
The item number and current setting (elapsed time in
the case of the digital clock) of the currently selected
menu item also appear in the time data display section.
The item number flashes to indicate that you can
switch to another item.
94
7-2 Basic Setup Menu
Video panel
VITC
FRAMES
B
F
LIGHT MONITOR
OFF ON OFF L H
5 4
SHUTTLE JOG
SUB THUMB
COUNTER
CLIP NAIL SHIFT
SEL HOLD
CLIP ESSENCE
MENU MARK
METER MONITOR
MENU SET RESET
SEL SEL
L/ST/R
SYSTEM
S.SEL
MENU MARK1
REC
IN OUT
MARK2
2
Display in video panel and on external monitor
Cursor indicating the currently selected item
Group name for the currently selected item
HOUR METER
*HO1 : OPE HOURS
H11 : OPE HOURS r-
Display in time data display
Item number (flashing)
To display the item name in the time data display
Hold down the NEXT button.
2
Rotate the jog dial or shuttle dial to select a menu item.
Rotate in the clockwise direction to select higher
numbers, and in the counterclockwise direction to
select lower number. The cursor moves in the direction
of the rotation (the screen scrolls when the cursor
reaches the top or bottom of the screen). The speed at
which the cursor moves and speed with which menu
items change vary with the rotation speed of the jog
dial or the rotation angle of the shuttle dial.
The STOP button lights when you select an item that
contains sub items.
3
When the selected item contains sub items, you can
select a sub item by holding down the STOP button
and rotating the jog dial or shuttle dial.
The displays in the video panel, on an external
monitor, and in the time data display section change as
shown below when you hold down the STOP button.
In the time data display section, the currently selected
sub item number flashes to indicate that you can
switch to another sub item.
- 109
109
Setting