Sony PDW-R1 Operation Manual page 105

Item Item name
number
713 VIDEO SETUP REFERENCE
Sub-item
1 INPUT LEVEL
2 OUTPUT LEVEL
723 INPUT VIDEO BLANK
Sub-item
1 ALL LINE
2 ... LINE 12 ...
10 LINE 20
2 ... LINE 9, 322
15 ...
LINE 22, 335
726 H BLANKING WIDTH
728 OUTPUT SCH PHASE
Menu items in the 700s, relating to video control
Settings
Select whether to remove the setup (7.5%) from the input analog video
signals and whether to add the setup (7.5%) to the output analog video
signals (when 525(U) or 525(J) line mode is selected).
Whether to remove the setup (7.5%) from the input analog video signals.
0.0%: Do not remove.
7.5%: Remove.
The factory default settings for each line mode are as follows:
525(U) line mode: 7.5%
525(J) line mode: 0.0%
Whether to add the setup (7.5%) to the output analog video signals.
0.0%: Do not add.
7.5%: Add.
The factory default settings for each line mode are as follows:
525(U) line mode: 7.5%
525(J) line mode: 0.0%
Switch blanking on or off for individual lines in the vertical blanking interval of
an input video signal. The Y/C signal and odd/even fields are blanked
simultaneously.
A signal with blanking carried out according to this setting is recorded.
- - -: Specify the blanking for each line separately.
blnk (blank): Regardless of the setting of other sub-items, blank all lines
which can be specified in this menu item.
thru (throu): Regardless of the setting of other sub-items, switch off blanking
for all lines which can be specified in this menu item.
In 525(U)/ Specify blanking for lines 12 to 20.
525(J) line blnk (blank): Carry out blanking.
modes thru (throu): Switch off blanking.
In 625 line Specify blanking for lines 9, 322 to 22, 335.
mode blnk (blank): Carry out blanking.
thru (throu): Switch off blanking.
Select the horizontal blanking width of the output analog video signal.
narow (narrow): Digital blanking (narrow)
wide: Analog blanking (wide)
When "wide" is selected, the horizontal blanking width complies with RS170A,
and normally the blanking is widened and the image becomes narrower. It is
recommended to select "narow" at the editing stage, then later, for broadcast
transmission to select "wide," to output a signal conforming to the standard.
Note, however, that "narow" has to be always selected for SDI signals.
Set the subcarrier H phase.
–512 (–512 (DEC))... 0 (0 (DEC))... 511 (511 (DEC))
105
7-3 Extended Menu