Before Using The Unit; Setting The Line Mode - Sony PDW-R1 Operation Manual

Before Using the Unit

Setting the Line Mode

This unit is shipped with the line mode still unset.
Therefore you need to set the line mode before using the
unit. (The unit cannot be used unless the line mode is set.)
Once it is set, the line mode is retained even when the unit
is powered off.
Setting procedure
Use the following procedure to set the line mode.
Time data display
DATA DATA DATA DATA
VITC VIUB COUNTER HOLD VITC
dB OVER dB OVER dB OVER dB OVER
0 0 0 0
PB NDF EXT-LK
-12 -12 -12 -12
-20 -20 -20 -20
-30 -30 -30 -30 HOURS MINUTES SECONDS FRAMES
-40 -40 -40 -40
-60 -60 -60 -60 DISC E B
CH- 15 CH- 26 CH- 37 CH- 48 BATT E F
PROCESS
AUDIO CONTROL
VIDEO
INPUT CH INPUT SEL INPUT SEL STATUS CHARACTER LIGHT MONITOR
WARNING KEY INHI REC INHI
OFF ON OFF ON OFF
1
AC power switch (rear panel)
KEY INHI TC COUNTER
ON SEL HOLD
NETWORK INT PRESET F-RUN
LOCAL EXT
ACCESS REMOTE
RP188 REGEN R-RUN
OFF
ALL/CH-1 CH-2 CH-3 CH-4
METER MONITOR
VARIABLE
SEL
REC
PRESET
PB
L/ST/R
AUDIO
PREV PLAY NEXT STOP REC
TOP F REV F FWD END
5
a) If you are using DC power or a battery pack, connect the DC power
or mount the battery pack on the battery pack shoe beforehand.
1
Power the unit on.
"Select ----" appears in the time data display.
2
With the SHUTTLE button held down, rotate the jog
dial.
When you rotate the jog dial in the forward direction,
the "----" part of the display changes in the sequence
525U > 525J > 625. When you rotate it in the reverse
direction, the display changes in the sequence 625 >
525J > 525U.
L H
a)
SHUTTLE JOG
SUB THUMB
SHIFT
CLIP NAIL
CLIP ESSENCE
MENU
MARK
SEL MENU SET RESET
SYSTEM S.SEL
MENU
MARK1
IN OUT
MARK2
4 2,3
Setting Line mode
525U 525(U): NTSC (areas outside Japan)
525J 525(J): NTSC (Japan)
625 625: PAL
3
When the desired setting appears, release the
SHUTTLE button.
"Push SET !!" appears.
To redo the selection
Repeat step 2.
4
Press the SET button.
"Turn OFF !!" appears.
5
Power the unit off, and then power it on again.
The selected line mode becomes available for use.
You can change the setting made with this procedure
by using basic menu item 013 "525/625 SYSTEM
SELECT." See 7-2-2 "Basic Menu Operations" (page
94) for more information about how to make basic
menu settings.
Note
The line mode is not set, or is cleared, in the following
situations. Reset the line mode.
• The unit is powered off before performing step 4 in the
previous procedure.
• The "RESET ALL SETUP" command in the
maintenance menu (see page 112) is executed.
Settings affected by the line mode
The following settings are affected when the line mode is
changed.
• Alarm message language
525(J): Japanese
525(U)/625: English
• The following menu item names, setting values, or
factory default setting values
7
Before Using the Unit