Suzuki SY413 Service Manual page 5324

8A-1-10 HOW TO USE THIS MANUAL
3. · Wiring of this vehicle uses joint connectors (J/C) which divide one wire into several different wires or
combine several different wires into one wire.
· The joint connector is illustrated below.
OPEN
How to Read Connector Codes and Pin Numbers. (How to Use Manual) :
It is possible to retrieve the location and shape of each connector from the connector code indicated in
"SYSTEM CIRCUIT DIAGRAM" section and the position of each pin from the connector pin No.
To retrieve location of connector :
Open "SYSTEM CIRCUIT DIAGRAM" section to consult the connector code of the questioned connec-
tor. Then, refer to "CONNECTOR LAYOUT DIAGRAM" section and look for the same code as the con-
nector code in question. The place where the code is found is the location of that connector.
To retrieve shape or pin No.
Open "SYSTEM CIRCUIT DIAGRAM" section to consult the connector code and pin No. of the ques-
tioned connector. Then, refer to "LIST OF CONNECTORS" section as shown at the right in the figure
below and look for the desired connector code under which the shape of that connector is shown. This
method is convenient when locating the connector in question among similar connectors. Also, by using
this page, it is possible to find the position of each pin from the connector pin No. provided in "SYSTEM
CIRCUIT DIAGRAM" section. It is helpful when retrieving pin position in the connector for checking con-
tinuity between pins.
To know the location, shape or pin position of the connector, cross-refer "SYSTEM CIRCUIT DIAGRAM",
"CONNECTOR LAYOUT DIAGRAM" and "LIST OF CONNECTOR" section as follows:
CONNECTOR LAYOUT DIAGRAM
Retrieve the connector location
WHT/BLK
RED/WHT
BLK
SYSTEM CIRCUIT DIAGRAM
Consult the connector code and
pin No.
CROSS-REFERENCE
BLK RED/YEL
BLK
BLK RED/YEL
LIST OF CONNECTORS
Retrieve shape or pin position
of the connector.