Suzuki SY413 Service Manual page 5163

1. Clutch plate
3. Washer
5) Adjust clearance, between clutch plate (1) and clutch pulley (2)
by putting shim on compressor shaft.
Standard clearance "a": 0.3 – 0.5 mm (0.012 – 0.020 in.)
6) Tighten new clutch plate bolt (2) as specified torque.
Tightening Torque
(a): 14 N·m (1.4 kg-m, 10.5 Ib-ft)
Special Tool
(A): 09991-06020
MECHANICAL SEAL
REMOVAL
1) Remove magnet clutch, referring to "C. MAGNET CLUTCH" in
this section.
2) Remove front head mounting screw (8 pcs).
1. Case
2. Front head
3) Remove front head pushing cylinder shaft.
NOTE:
Be careful not to remove cylinder from case.
4) Remove O-ring.
1. Front head
2. Cylinder shaft
3. Cylinder
4. Case
5. O-ring
5) Remove mechanical seal from front head.
1. Front head
2. Bearing puller
AIR CONDITIONING (OPTIONAL) S-1B-9