Suzuki SY413 Service Manual page 5160

S-1B-6 AIR CONDITIONING (OPTIONAL)
MAGNET CLUTCH
INSPECTION
Clutch plate and pulley
1) Check clutch plate and clutch pulley for wear and oil soaked
conditions respectively.
2) Check clutch pulley bearing for noise, wear and grease leak-
age.
If there is any defect for clutch plate and clutch pulley, replace
magnet clutch component.
Thermal switch
1) Disconnect thermal switch read wire (1) from clutch coil read
wire.
2) Use an ohmmeter (2) to check thermal switch (3) for continuity.
If it is no continuity, replace thermal switch.
Clutch coil
1) Remove diode component (1) by loosening tightening bolt (2).
2) Use an ohmmeter (3), check resistance of clutch coil read wire
(4) and compressor body (5).
If checked resistance is not within tolerance, replace magnet
clutch component.
Standard resistance: 3.0 – 4.0 W
1. Clutch plate bolt
2. Clutch plate
3. Circlip
4. Clutch pulley
5. Washer
6. Shim
7. Diode component
8. Clutch coil
9. Lip type seal
10. Compressor front head
11. Compressor body assembly
12. O-ring
13. Compressor thermal switch
14. Magnet clutch component