Suzuki SY413 Service Manual page 4966

AIR CONDITIONING (OPTIONAL)
WARNING:
For vehicles equipped with Supplemental Restraint (Air Bag) System:
D Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "System Components and Wiring Location View" under "Gen-
eral Description" in air bag system section in order to confirm whether you are performing service
on or near the air bag system components or wiring. Please observe all WARNINGS and "Precau-
tions" in air bag system section before performing service on or around the air bag system com-
ponents or wiring. Failure to follow WARNINGS could result in unintentional activation of the
system or could render the system inoperative. Either of these two conditions may result in se-
vere injury.
D Technical service work must be started at least 90 seconds after the ignition switch is turned to
the "LOCK" position and the negative cable is disconnected from the battery. Otherwise, the sys-
tem may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
CAUTION:
The air conditioning system of this model uses Refrigerant HFC-134a (R-134a).
NOTE:
D For the descriptions (items) not found in this section, refer to the same section of the Service Manual
mentioned in FOREWORD of this manual.
D Two types of A/C compressors, "SANDEN" and "SEIKO SEIKI", are used depending on the suppliers.
When the compressor of "SEIKO SEIKI" is equipped to the car, first refer to the Service Bulletin S-1B
of this manual.
COMPRESSOR IDENTIFICATION
The manufacturer of the compressor can be identified by the label on the A/C compressor as shown below.
SECTION 1B
AIR CONDITIONING (OPTIONAL) 1B-1
1B