Suzuki SY413 Service Manual page 4976

1. Puller
2. Compressor
3) Remove shims from shaft.
4) Remove drive clutch.
5) With special tool (D) in place, remove magnet clutch with puller.
6) Remove magnet clutch coil.
INSTALLATION
1) Install magnet clutch coil.
2) Using special tool (C), install snap ring as shown.
1. Snap ring
2. Clutch coil
3. Compressor assembly
3) Install magnet clutch.
Using special tool (C), remove circlip.
Special Tool
(C): 09900-06107
Special Tool
(D): 09951-65510
NOTE:
Be careful not to damage pulley when tapping drive clutch.
Protrusion on under side of coil ring must match hole in com-
pressor assembly to prevent movement ant correctly locate
lead wire.
Special Tool
(C): 09900-06107
i) Set magnet clutch squarely over clutch, installation boss.
ii) Place special tool (E) onto clutch bearing.
Ensure that edge rests only on inner race of bearing.
iii)Install snap ring.
Special Tool
(E): 09951-15510
CAUTION:
Be careful not to scratch bearing seal.
AIR CONDITIONING (OPTIONAL) 1B-11