Suzuki SY413 Service Manual page 4978

1. Oil felt retainer
2).Compressor
1. Key
2. Driver
1. Circlip
1. Mechanical seal
MECHANICAL SEAL
REMOVAL
1) Remove magnet clutch, referring to "MAGNET CLUTCH" in this
section.
2) Pry out retainer with oil felt, by using special tool (C).
Special Tool
(C): 09900-06107
3) Remove key.
Using a hammer and driver, drive key from shaft.
4) Remove circlip, by using special tool (F).
SpecIal Tool
(F): 09900-06108
5) Remove mechanical seal using special tool (G). The following
explains this removal procedure.
i) Fit special tool (G) into clutch installation boss.
ii) Twist special tool until 2 lips on tool fit in slot in mechanical
seal housing.
Special Tool
(G): 09990-48230
iii)Pull up special tool (G) to remove mechanical seal.
AIR CONDITIONING (OPTIONAL) 1B-13