Suzuki SY413 Service Manual page 5150

09931-76011
Tech 1A kit
Mass storage cartridge
PROCEDURE AFTER FUEL PUMP
ASSEMBLY REPLACEMENT
CAUTION:
When fuel pump assembly was replaced, including when
replaced because rechecking by using a known-good
fuel pump assembly was necessary during trouble diag-
nosis, be sure to register fuel pump/immobilizer control
module code in immobilizer control module and fuel
pump by performing the following procedure. Other-
wise, immobilizer control system can not be operated.
1) Perform Steps 1) and 2) described in "How to Register Ignition
Key".
2) Turn ignition switch ON.
3) Using SUZUKI scan tool, register fuel pump/immobilizer control
module code in immobilizer control module by executing "F1:
RECORD ECU" command in SELECT MODE menu.
NOTE:
For operation procedure of SUZUKI scan tool, refer to SU-
ZUKI scan tool operator's manual.
SPECIAL TOOLS
1. Storage case
2. Operator's manual
3. Tech 1A
4. DLC cable
5. Test lead/probe
6. Power source cable
7. DLC cable adapter
8. Self-test adapter
09931-76030
16/14 pin DLC cable
IMMOBILIZER CONTROL SYSTEM (IF EQUIPPED) 8A-21
Immobilizer cartridge 1.2