Table of Contents
Advertisement
124 Driving and parking
Raising and lowering the vehicle level
Using the remote control
The remote control is located in a holder on the
B‑pillar on the driver's side. Remove the remote
control from the holder before use.
Electronic level control performs a self-check reg‐
ularly when it is activated and while in use. Indi‐
cator lamp
1
on the remote control lights up for
approximately one second when you switch on
either the ignition or electronic level control with
button 4.
There is a malfunction if indicator lamp
behaves in the following ways:
the indicator lamp does not light up when you
R
switch on the ignition or electronic level con‐
trol
or
the indicator lamp does not go out after one
R
second
or
the indicator lamp then lights up again or
R
flashes
In addition, a warning tone is emitted from the
remote control for approximately 30 seconds.
The fault that has been detected can be shown
using the indicator lamps (signaling of fault
codes).
Park the vehicle, leaving the ignition switched
#
on.
To raise or lower the vehicle level: press
#
and hold button
2
level reaches the required height.
The indicator lamp on button
flashes as long as the vehicle level is being
changed. When the vehicle level has been set,
the indicator lamp on button
up.
1
or
3
until the vehicle
2
or
3
2
or
3
lights
To lower automatically: briefly press button
#
3.
Electronic level control automatically lowers
the vehicle down to the lowest position.
The indicator lamp on button
long as the vehicle level is being changed.
When the vehicle level has been set, the indi‐
cator lamp on button
To stop the movement, briefly press button
#
2.
To raise or lower to driving level: briefly
#
press button
2
or 3.
Electronic level control automatically raises or
lowers the vehicle to driving level.
The indicator lamp on button
flashes as long as the vehicle level is being
changed. When the vehicle level has been set,
the indicator lamp on button
up.
To stop the movement, briefly press the other
#
button.
To save the set vehicle level: set the
#
required vehicle level.
Press and hold button
#
a tone.
The vehicle level set has been saved on corre‐
sponding button
5
To call up the saved vehicle level: briefly
#
press button
5
or 6.
Electronic level control automatically raises or
lowers the vehicle to the saved driving level.
The indicator lamp on button
flashes as long as the vehicle level is being
changed. When the vehicle level has been set,
the indicator lamp on button
up.
To stop the movement, briefly press button
#
2
or 3.
To switch on automatically: drive at over
#
6.2 mph (10 km/h) or release the parking
brake.
Electronic level control controls the vehicle
level automatically.
To stop the movement, briefly press button
#
2
or 3.
Switching electronic level control off/on
To switch electronic level control off:
#
press button 4.
The indicator lamp on button
3
flashes as
3
lights up.
2
or
3
2
or
3
lights
5
or
6
until you hear
or 6.
5
or
6
5
or
6
lights
4
lights up.
Advertisement
Table of Contents
