Loading The Vehicle; Tire And Loading Information Placard; Restarting The Tire Pressure Monitor; Radio Equipment Approval Numbers - Mercedes-Benz Sprinter 2019 Operating Instructions Manual

302 Wheels and tires
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
R

Restarting the tire pressure monitor

Requirements:
The recommended tire pressure is correctly
R
set for the respective operating condition on
each of the wheels (
Restart the tire pressure monitoring sys‐
R
tem in the following situations:
The tire pressure has changed.
-
The wheels or tires have been changed or
-
newly installed.
On-board computer:
Service Tires
4 5
Scroll down in the menu.
#
The Use Current Pressures as New Refer-
ence Values message appears in the multi‐
function display.
Confirm the message to initiate a restart.
#
The Tire Press. Monitor Restarted
appears in the multifunction display.
Current warning messages are deleted and
the h yellow warning lamp goes out.
After you have driven for a few minutes, the
system checks whether the current tire pres‐
sures are within the specified range. The cur‐
rent tire pressures are then accepted as ref‐
erence values and monitored.
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
R
page 296)
/
page 296).
/
message
page 296)
/
Radio-equipment approval of the tire pres‐
sure monitoring system

Radio equipment approval numbers

Country Radio equipment approval
number
Canada IC: 4008C-TSSRE4A
Operation is subject to the follow‐
ing two conditions:
(1) this device may not cause
harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
Mexico Model: TSSRE4A & TSSSG4G6,
IFETEL: RLVHUTS17-0806
USA FCC ID: YGOTSSRE4A
This device complies with Part 15
of the FCC Rules. Operation is
subject to the following two con‐
ditions: (1) this device may not
cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
WARNING: Any changes or modifi‐
cation not expressly approved by
the party responsible for compli‐
ance could void the user's author‐
ity to operate this equipment.

Loading the vehicle

Tire and Loading Information placard

& WARNING Risk of an accident when driv‐
ing with an overloaded tire
Overloaded tires may overheat and burst as a
consequence. Overloaded tires can also
impair the steering and handling characteris‐
tics and lead to brake failure.
Observe the load rating of the tires.
#
The load rating must be at least half the
#
gross axle weight rating of the vehicle.
Mercedes-Benz recommends you use
the load-bearing index, which is given in
the vehicle documents.