88
Light and vision
Switch off the lighting system.
#
Place a screwdriver, for example, at opening
#
2
between lamp
3
fully pry off lamp 3.
Remove lamp
3
from panel 1.
#
Rotate the bulb holder by around 45° and
#
detach it from the lamp.
Remove the light bulb.
#
Insert the new bulb into the bulb holder.
#
Insert the bulb holder into the lamp and
#
rotate it by around 45°.
Insert the lamp into the panel opening until it
#
engages.
Replacing rear light bulbs (chassis)
Overview of rear bulb types (chassis)
You can change the following bulbs.
Vehicles with standard tail lamps
1
Clearance lamp: R 5 W
2
Tail light: R 5 W
3
Brake light: P 21 W
4
Turn signals: PY 21 W
5
Reversing lights: P 21 W
6
Rear fog light (driver's side): P 21 W
7
License plate lamp: R 5 W
and panel
1
and care‐
Replacing the tail lamps on the chassis
Requirements:
Rear fog lights: bulb type P 21 W
R
License plate lighting: bulb type R 5 W
R
Reversing lights: bulb type P 21 W
R
Turn signal indicators: bulb type PY 21 W
R
Clearance lamp: bulb type R 5 W
R
Brake light: bulb type P 21 W
R
Taillight: bulb type R 5 W
R
1
Light lens
2
Screws
3
Rear fog light
4
License plate lamp
5
Reversing light
6
Turn signal indicator
7
Clearance lamp
8
Brake light
9
Taillight
Switch off the lighting system.
#
Unscrew screws
1
#
2.
Remove the plug connector from the lamp
#
carrier.
Gently turn the bulb counter-clockwise and
#
take it out of the socket.
Insert the new bulb into the socket and turn it
#
clockwise.
Position light lens
2
#
and remove light lens
and tighten screws 1.