Hoshizaki IM-240DME Service Manual page 91

12. CAM ARM 12. CAM ARM
[a] CAM ARM (A) - ACTUATOR MOTOR SIDE [a] CAM ARM (A) - ACTUATOR MOTOR SIDE
Refer to "11. ACTUATOR MOTOR." Refer to "11. ACTUATOR MOTOR."
[b] CAM ARM (B) - REAR SIDE [b] CAM ARM (B) - REAR SIDE
1) Remove the Top Panel and Front Panel. 1) Remove the Top Panel and Front Panel.
2) Push the Reset Switch on the Control Box to open the Water Pan. 2) Push the Reset Switch on the Control Box to open the Water Pan.
3) Unplug the icemaker or disconnect the power source. 3) Unplug the icemaker or disconnect the power source.
4) Remove the Extension Spring from the Cam Arm (B). 4) Remove the Extension Spring from the Cam Arm (B).
5) Remove the Split Pin from the Cam Shaft. 5) Remove the Split Pin from the Cam Shaft.
6) Remove the Cam Arm (B). 6) Remove the Cam Arm (B).
7) Install the new Cam in the reverse order of the removal procedure. 7) Install the new Cam in the reverse order of the removal procedure.
8) Replace the panels in their correct positions. 8) Replace the panels in their correct positions.
9) Plug in the icemaker or connect the power source. 9) Plug in the icemaker or connect the power source.
E1CG4880210 E1CG4880210
87 87