Hoshizaki IM-240DME Service Manual page 90

11. ACTUATOR MOTOR 11. ACTUATOR MOTOR
1) Remove the Top Panel and Front Panel. 1) Remove the Top Panel and Front Panel.
2) Push the Reset Switch on the Control Box to open the Water Pan. 2) Push the Reset Switch on the Control Box to open the Water Pan.
3) Unplug the icemaker or disconnect the power source. 3) Unplug the icemaker or disconnect the power source.
4) Remove the Extension Spring (Actuator Motor side) from the Cam Arm. 4) Remove the Extension Spring (Actuator Motor side) from the Cam Arm.
5) Disconnect the Actuator Motor leads in the Wiring Channel. 5) Disconnect the Actuator Motor leads in the Wiring Channel.
6) Remove the Actuator Motor Bracket. 6) Remove the Actuator Motor Bracket.
7) Remove the Spring Pin securing the Shaft to the Cam Arm. 7) Remove the Spring Pin securing the Shaft to the Cam Arm.
8) Remove the Actuator Motor. 8) Remove the Actuator Motor.
9) Install the new Actuator Motor in the reverse order of the removal procedure. 9) Install the new Actuator Motor in the reverse order of the removal procedure.
10) Check and adjust so that the Cam Arm normally moves the Actuator Toggle Switch to the 10) Check and adjust so that the Cam Arm normally moves the Actuator Toggle Switch to the
"FREEZE" and "DEFROST" positions (See "II. 2. [b] BEFORE CHECKING "FREEZE" and "DEFROST" positions (See "II. 2. [b] BEFORE CHECKING
CONTROLLER BOARD"). CONTROLLER BOARD").
11) Replace the panels in their correct positions. 11) Replace the panels in their correct positions.
12) Plug in the icemaker or connect the power source. 12) Plug in the icemaker or connect the power source.
86 86
E1CG4880210 E1CG4880210