Hoshizaki IM-240DME Service Manual page 56

Stackable cuber
Hide thumbs Also See for IM-240DME:
Table of Contents

Advertisement

7) When the icemaker stops, release the Bin Control Switch into the
7) When the icemaker stops, release the Bin Control Switch into the
"running" position. See Fig. 44. (The icemaker will restart in 80
"running" position. See Fig. 44. (The icemaker will restart in 80
seconds, and the Water Pan will start to open.)
seconds, and the Water Pan will start to open.)
8) Close the water supply tap.
8) Close the water supply tap.
9) After the ice has dropped and the Water Pan begins to close, move
9) After the ice has dropped and the Water Pan begins to close, move
the Washing Switch on the right side of the Control Box to the
the Washing Switch on the right side of the Control Box to the
"WASH" position. See Fig. 45.
"WASH" position. See Fig. 45.
10) As soon as the Water Pan closes, pour the cleaning solution prepared in 1) carefully into
10) As soon as the Water Pan closes, pour the cleaning solution prepared in 1) carefully into
the Water Pan. Do not splash or spill the solution onto the other parts.
the Water Pan. Do not splash or spill the solution onto the other parts.
11) Circulate the cleaning solution for 30 minutes. Open the water supply tap, and repeat the
11) Circulate the cleaning solution for 30 minutes. Open the water supply tap, and repeat the
above steps 6) and 7).
above steps 6) and 7).
12) When the Water Pan closes again, pour clean water into the Water Pan until it floods from
12) When the Water Pan closes again, pour clean water into the Water Pan until it floods from
the Overflow Pipe, and circulate the water for 5 minutes.
the Overflow Pipe, and circulate the water for 5 minutes.
13) Repeat the above steps 6), 7) and 12) at least three times to rinse thoroughly.
13) Repeat the above steps 6), 7) and 12) at least three times to rinse thoroughly.
SANITIZING INSTRUCTIONS
SANITIZING INSTRUCTIONS
Note: Sanitizing should always be completed after cleaning or alternately as an individual
Note:
Sanitizing should always be completed after cleaning or alternately as an individual
procedure if conditions exist to make it necessary.
procedure if conditions exist to make it necessary.
14) Use a suitable container to dilute 44 ml of 5.25% sodium hypochlorite solution with 11.4
14) Use a suitable container to dilute 44 ml of 5.25% sodium hypochlorite solution with 11.4
lit. of water.
lit. of water.
* Alternatively use the Hoshizaki recommended sanitizer as directed by the relevant
* Alternatively use the Hoshizaki recommended sanitizer as directed by the relevant
instructions.
instructions.
15) Repeat the above steps 5), 6) and 7), and close the water supply tap.
15) Repeat the above steps 5), 6) and 7), and close the water supply tap.
Washing Switch
Washing Switch
Control Box
Control Box
Fig. 45
Fig. 45
52
52
Fig. 44
Fig. 44
E1CG4880210
E1CG4880210

Advertisement

Table of Contents
loading

Table of Contents