Hoshizaki IM-240DME Service Manual page 73

4. OTHERS
PROBLEM
[1] Icemaker will
not stop when
Bin is filled with
ice.
[2] Abnormal
noise
[3] Ice in Storage
Bin often melts.
[4] Fan Motor
does not
change speed
(DME/XME
only)
E1CG4880210
CHECK
a) Bin Control 1. Out of position.
Switch
2. Bad contacts.
b) Controller Board 1. See "II. 2. CONTROLLER BOARD".
a) Pump Motor 1. Bearing worn out.
b) Actuator Motor 1. Gears worn out.
c) Fan Motor 1. Bearings worn out.
2. Fan Blade deformed.
3. Fan Blade does not move
d) Compressor 1. Mounting pad out of
e) Refrigerant 1. Rubbing or touching on
Lines
a) Bin Drain 1. Plugged.
a) Bimetal 1. Defective.
Thermostat
b) Fan Relay X6 1. Welded contacts or
POSSIBLE CAUSE
freely.
position.
other surfaces.
defective coil.
69
REMEDY
1. Place in position.
2. Check for continuity and
replace.
1. Replace.
1. Replace.
1. Replace.
2. Replace Fan Blade.
3. Replace.
1. Reinstall.
1. Secure or reset pipes.
1. Clean.
1. Replace.
1. Replace.