Hoshizaki IM-240DME Service Manual page 28

1) After removing the packaging, make sure that the icemaker and the Storage Bin are in 1) After removing the packaging, make sure that the icemaker and the Storage Bin are in
good condition. If in doubt, please do not use the equipment. See the instruction sheet good condition. If in doubt, please do not use the equipment. See the instruction sheet
attached to the Storage Bin for its unpacking and installation guidelines. attached to the Storage Bin for its unpacking and installation guidelines.
2) Remove the icemaker panels to gain access to the accessory kit and to assist easier 2) Remove the icemaker panels to gain access to the accessory kit and to assist easier
installation. installation.
[IM-240D, IM-240A] [IM-240D, IM-240A]
a) Front Panel: Remove the screw(s). Lift up and pull toward you. a) Front Panel:
b) Top Panel: b) Top Panel:
c) Side Panel: c) Side Panel: Remove the screw(s). Slide forward slightly, and
d) Rear Panel: d) Rear Panel: Does not require removal.
3) Remove the package of accessories, and check the contents: 3) Remove the package of accessories, and check the contents:
a) Installation Kit a) Installation Kit
Inlet Hose Inlet Hose
Outlet Hose (Air-Cooled) Outlet Hose
1/2-3/4 Nipple (Water-Cooled) 1/2-3/4 Nipple (Water-Cooled)
b) Scoop (Except IM-240X) b) Scoop (Except IM-240X)
c) Ice Chute (IM-240X, IM-240A) c) Ice Chute (IM-240X, IM-240A)
d) Drain Pipe Collar (IM-240X only) d) Drain Pipe Collar (IM-240X only)
e) Packing (IM-240X only) e) Packing (IM-240X only)
4) Remove the shipping tape holding the Bin Control Switch. 4) Remove the shipping tape holding the Bin Control Switch.
5) Remove the protective plastic film from the exterior. If the icemaker is exposed to the sun 5) Remove the protective plastic film from the exterior. If the icemaker is exposed to the sun
or to heat, remove the film after the icemaker cools. or to heat, remove the film after the icemaker cools.
Remove the screw(s). Lift up and pull toward you.
Remove the screw(s). Simply lift off. Remove the screw(s). Simply lift off.
Remove the screw(s). Slide forward slightly, and
then lift off. then lift off.
Does not require removal.
Fig. 2 Fig. 2
(Air-Cooled) (Air-Cooled)
(Water-Cooled) (Water-Cooled)
(Remote Air-Cooled) (Remote Air-Cooled)
(Air-Cooled)
(Water-Cooled) (Water-Cooled)
(Remote Air-Cooled) (Remote Air-Cooled)
24 24
[IM-240X] [IM-240X]
Drain Outlet Drain Outlet
(No top panel, (No top panel,
Drain Outlet on the left) Drain Outlet on the left)
1 1
2 2
1 1
1 1
2 2
1 1
2 2
1 1
1 1
1 1
1 1
E1CG4880210 E1CG4880210