Hoshizaki IM-240DME Service Manual page 47

[Remote Air-cooled Model] [Remote Air-cooled Model]
Before starting the unit, energise the Oil Heater around the lower part of the Compressor to Before starting the unit, energise the Oil Heater around the lower part of the Compressor to
prevent a starting failure caused by the refrigerant staying inside the Compressor: prevent a starting failure caused by the refrigerant staying inside the Compressor:
1) Move the Washing Switch on the Control Box to the "WASH" position. 1) Move the Washing Switch on the Control Box to the "WASH" position.
2) Push the Bin Control Switch to the right into the "bin full" position, 2) Push the Bin Control Switch to the right into the "bin full" position,
and fix it there with tapes. and fix it there with tapes.
3) Connect the power supply. 3) Connect the power supply.
4) After 10 seconds in the defrost cycle, the unit stops. Leave the unit 4) After 10 seconds in the defrost cycle, the unit stops. Leave the unit
for 12 hours (Oil Heater energised). for 12 hours (Oil Heater energised).
5) Move the Washing Switch to the "ICE" position, and release the Bin Control Switch into the 5) Move the Washing Switch to the "ICE" position, and release the Bin Control Switch into the
initial "running" position. initial "running" position.
6) The unit will start a freeze cycle in 80 seconds. 6) The unit will start a freeze cycle in 80 seconds.
1. Check the conditions and quality of the ice production. 1. Check the conditions and quality of the ice production.
2. Do not use ice produced in the trial run. It might be contaminated with foreign 2. Do not use ice produced in the trial run. It might be contaminated with foreign
matter in the water circuit. Discard or flush down the drain. matter in the water circuit. Discard or flush down the drain.
E1CG4880210 E1CG4880210
Washing Washing
Switch Switch
Control Box Control Box
Fig. 33 Fig. 33
Fig. 35 Fig. 35
IMPORTANT IMPORTANT
43 43
Fig. 34 Fig. 34