Configure Digital Communications - Emerson Micro Motion 2700 Configuration And Use Manual

Options for Enhanced Event Action
Action
Standard
None (default)
Start sensor zero
Start/stop all totalizers
Reset mass total
Reset volume total
Reset gas standard volume
total
Reset all totals
Petroleum measurement
Reset temperature-correc-
ted volume total
Concentration measurement
Reset CM reference volume
total
Reset CM net mass total
Reset CM net volume total
Increment CM matrix
Meter verification
Start meter verification test
Note
Before assigning actions to an enhanced event, check the status of the event. If it is ON, all assigned
actions will be performed when the new configuration is implemented. If this is not accepatable,
wait until an appropriate time to assign actions to the event.
6.6

Configure digital communications

The digital communications parameters control how the transmitter will communicate
using digital communications.
Your transmitter supports the following types of digital communications:
•
•
Configuration and Use Manual
Display
NONE
START ZERO
START STOP
RESET MASS
RESET VOL
RESET GSVT
RESET ALL
TCVOL
RESET STD V
RESET NET M
RESET NET V
INCr CURVE
START VERFY
HART/Bell 202 over the primary mA terminals
Modbus RTU via the service port
Integrate the meter with the control system
Label
ProLink III
None
Start Sensor Zero
Start/Stop All Totalization
Reset Mass Total
Reset Volume Total
Reset Gas Std Volume Total
Reset All Totals
Reset Volume Total at Reference
Temperature
Reset Volume Total at Reference
Temperature
Reset Net Mass Total
Reset Net Volume Total
Increment Concentration Matrix
Start Meter Verification
Field Communicator
None
Perform auto zero
Start/stop totals
Reset mass total
Reset volume total
Reset gas standard volume total
Reset totals
Reset corrected volume total
Not available
Not available
Not available
Not available
Not available
109